Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSPECTION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (w/o Side Marker Light)


    E177947E06
  1. Apply battery voltage to the connector and check the light comes on.

    Standard Voltage:
    Condition
    Specified Condition
    Battery positive (+) → 1 (B)
    Battery negative (-) → 2 (E)
    Turn signal light comes on
    Battery positive (+) → 3 (STP)
    Battery negative (-) → 2 (E)
    Stop light comes on
    Battery positive (+) → 4 (TL)
    Battery negative (-) → 2 (E)
    Tail light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination Light Socket and Wire Sub-assembly)
    If the result is not as specified, replace the bulb or the rear combination light socket and wire sub-assembly.



2. INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY (w/ Side Marker Light)


    E177947E07
  1. Apply battery voltage to the connector and check the light comes on.

    Standard Voltage:
    Condition
    Specified Condition
    Battery positive (+) → 4 (B)
    Battery negative (-) → 2 (E)
    Turn signal light comes on
    Battery positive (+) → 3 (STP)
    Battery negative (-) → 2 (E)
    Stop light comes on
    Battery positive (+) → 1 (TL)
    Battery negative (-) → 2 (E)
    Tail and Side marker light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination Light Socket and Wire Sub-assembly)
    If the result is not as specified, replace the bulb or the rear combination light socket and wire sub-assembly.