Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT BACK-UP LIGHT SOCKET AND WIRE


    B314144E01
  1. Apply battery voltage to the connector and check the light comes on.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 3 (E)
    Back-up light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Back-Up Light Socket and Wire)
    If the result is not as specified, replace the bulb or the back-up light socket and wire.



2. INSPECT BACK-UP LIGHT SOCKET AND WIRE (w/ Rear Fog Light)


    B314144E02
  1. Apply battery voltage to the connector and check the light comes on.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Condition
    Specified Condition
    Battery positive (+) → 2 (B)
    Battery negative (-) → 3 (E)
    Rear fog light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Back-Up Light Socket and Wire)
    If the result is not as specified, replace the bulb or the back-up light socket and wire.