Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY


  1. Check the wire harness.

    1. Disconnect the air conditioner tube and accessory assembly connector.



    2. E246513E01
    3. Using an ohmmeter, measure the resistance of the wire harness side connector.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 - Body ground
      Always
      Below 1 Ω
      2 - 4
      Ignition switch ON
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (air conditioner tube and accessory assembly)



  1. Check the air conditioning pressure sensor.

    1. Install a manifold gauge set.



    2. E254250E01
    3. Apply pressure on the sensor as indicated in the table below, and check the resistance between the terminals.
      Text in Illustration 
      *1
      Sensor Part

      Standard Resistance:
      for HFC-134a (R134a):
      Tester Connection
      Condition
      Specified Condition
      1 - 4
      0 kPa (No Pressure applied)
      10 kΩ or higher
      1 - 4
      1520 kPa (15.5 kgf/cm2, 221 psi)
      Below 1 Ω
      2 - 3
      0 kPa (No Pressure applied)
      10 kΩ or higher
      2 - 3
      22.5 kPa (0.23 kgf/cm2, 33.0 psi) or more and below 3140 kPa (32 kgf/cm2, 455 psi)
      Below 1 Ω
      2 - 3
      3140 kPa (32 kgf/cm2, 455 psi) or more
      10 kΩ or higher

      Standard Resistance:
      for HFO-1234yf (R1234yf):
      Tester Connection
      Condition
      Specified Condition
      1 - 4
      0 kPa (No Pressure applied)
      10 kΩ or higher
      1 - 4
      1520 kPa (15.5 kgf/cm2, 221 psi)
      Below 1 Ω
      2 - 3
      0 kPa (No Pressure applied)
      10 kΩ or higher
      2 - 3
      248 kPa (2.53 kgf/cm2, 36.5 psi) or more and below 2980 kPa (30.4 kgf/cm2, 438 psi)
      Below 1 Ω
      2 - 3
      2980 kPa (30.4 kgf/cm2, 438 psi) or more
      10 kΩ or higher