Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH

LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH > INSPECTION

for Preparation Click here


HINT:
Use the same procedure for the LHD and RHD vehicles.



1. INSPECT LUGGAGE DOOR OPENING SWITCH ASSEMBLY


    B310913E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 1
    Pushed (ON)
    Below 1 Ω
    4 - 1
    Not pushed (OFF)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Luggage Door Opening Switch Assembly)
    If the result is not as specified, replace the switch assembly.