Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH

LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH > INSPECTION

for Preparation Click here


HINT:
Use the same procedure for the LHD and RHD vehicles.



1. INSPECT LUGGAGE DOOR OPENING SWITCH ASSEMBLY


    B370939E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Measurement Condition
    Switch Condition
    Specified Condition
    4 - 1
    Pushed (ON)
    Below 1 Ω
    4 - 1
    Not pushed (OFF)
    10 kΩ or higher

  1. Apply battery voltage to the connector and check that the luggage door opening switch light comes on.
    OK:  
    Tester Condition
    Condition
    Specified Condition
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 2
    Always
    Luggage door opening switch light comes on
    Text in Illustration 
    *a
    Component without harness connected
    (Luggage Door Opening Switch Assembly)
    If the result is not as specified, replace the luggage door opening switch assembly.