Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > INSPECTION

for Preparation Click here


HINT:
Use the same procedure for the LHD and RHD vehicles.



1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    B370504E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 - 3
    Pushed (ON)
    Below 1 Ω
    6 - 3
    Not pushed (OFF)
    10 kΩ or higher

  1. Apply battery voltage between the terminals of the light, and check the operation of the light.

    OK:
    Tester Condition
    Specified Condition
    Battery positive (+) → terminal 5
    Battery negative (-) → terminal 4
    LED illuminate

    Text in Illustration 
    *a
    Component without harness connected
    (Tire Pressure Warning Reset Switch)
    If the result is not as specified, replace the tire pressure warning reset switch.