Home › General › SPECIFICATIONS › FA20 ENGINE CONTROL

FA20 ENGINE CONTROL > SERVICE DATA



Spark plug
Resistance
Spark plug (terminal part) - Body ground
Always
10 MΩ or higher
Camshaft timing oil control valve assembly
Resistance
1 - 2
20°C (68°F)
6.85 to 7.65 Ω
Throttle with motor body assembly
Resistance
2 (M+) - 1 (M-)
20°C (68°F)
0.3 to 100 Ω
Idle speed
After the engine is warmed up
650 to 800 rpm
Accelerator pedal assembly
Voltage
Accel sensor out No. 1
Released
0.213 to 4.772 V
Depressed
0.213 to 4.772 V
Voltage
Accsel sensor out No. 2
Released
0.213 to 4.772 V
Depressed
0.213 to 4.772 V
Mass air flow meter
MAF
Engine not running
30 seconds after turning ignition switch to ON
0.47 gm/sec or less
Resistance
1 (THA) - 2 (E2)
-20°C (-4°F)
13.6 to 18.4 kΩ
20°C (68°F)
2.21 to 2.69 kΩ
60°C (140°F)
0.49 to 0.67 kΩ
Crankshaft position sensor
1 - 2
Always
1836 to 2244 Ω
Engine coolant temperature sensor
Resistance
Approx. 20°C (68°F)
2.35 to 2.65 kΩ
Approx. 80°C (176°F)
0.305 to 0.331 kΩ
Engine oil temperature sensor
Resistance
Approx. 20°C (68°F)
2.25 to 2.65 kΩ
Approx. 80°C (176°F)
0.305 to 0.331 kΩ
Knock sensor
Resistance
20°C (68°F)
532 to 588 kΩ
Air fuel ratio sensor
Resistance
1 - 2
20°C (68°F)
1.98 to 2.64 Ω
Resistance
1 - 4
Always
10 kΩ or higher
Heated oxygen sensor
Resistance
1 - 2
20°C (68°F)
5.0 to 6.4 Ω
Resistance
1 - 4
Always
10 kΩ or higher
EFI MAIN 1 RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω
EFI MAIN 2 RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω
EFI MAIN 3 RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω
IG2 RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω
INJ RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω
ETCS RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω
C/OPEN RELAY
Resistance
3 - 5
Battery voltage not applied to 1 and 2 terminals
10 kΩor higher
Battery voltage applied to 1 and 2 terminals
Below 1 Ω