REAR DRIVE SHAFT ASSEMBLY > REASSEMBLY |
| 1. INSTALL EBJ BOOT |
Wrap the shaft splines with vinyl tape.
Install the EDJ boot in the specified position, and fill of the specified grease.
| 2. INSTALL EDJ BOOT |
Place the EDJ boot at the center of the shaft.
![]() |
Insert the EDJ cage onto the shaft.
| *1 | EDJ Cage |
| *a | Cutout Portion |
| 3. INSTALL EDJ INNER RACE |
![]() |
Install the EDJ inner race on the shaft and fix the rear drive the shaft snap ring in place using pliers.
| 4. INSTALL EDJ CAGE |
![]() |
Install the EDJ cage to EDJ inner race fixed upon the shaft.
| *1 | EDJ Cage |
| *2 | EDJ Inner Race |
Fill of the specified grease into the inner side of the EDJ outer race.
Apply a thin coat of the specified grease to the cage pocket and 8 ball bearings.
Insert the 8 ball bearings into the cage pocket.
![]() |
Align the outer race track and ball positions, and place the shaft, EDJ inner race, cage and ball bearings in the original positions, and then fix the outer race in place.
| *1 | Outer Race |
| *2 | Grease |
| *3 | Balls (8 Pieces) |
![]() |
Install the circlip B in the groove on the EDJ outer race.
NKG814 apply an even coat of the specified grease to the entire inner surface of the boot. Also apply grease to the shaft.
Install the EDJ boot taking care not to twist it.
| 5. INSTALL REAR NO. 2 DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP |
Apply NKG814 grease to the interior surface of the new rear No. 2 drive shaft outboard joint boot clamp.
![]() |
Mount the rear No. 2 drive shaft outboard joint boot clamp to the EDJ boot, and temporarily bend the lever.
![]() |
While pushing the joint towards the work surface, press down using one hand, and fold the lever while turning the drive shaft forward.
| *a | Weight |
| *b | Ground |
![]() |
Using a plastic hammer, tap the buckle to affix.
| 6. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP |
![]() |
Install a new rear drive shaft outboard joint boot clamp to the EDJ boot and temporarily bend the lever.
![]() |
Use water pump pliers to tighten the rear drive shaft outboard joint boot clamp, and temporarily fasten.
| *a | The End is Near the Center of the Lever. |
![]() |
Use a plastic hammer to tap the buckle to affix.
| 7. INSTALL REAR NO. 2 DRIVE SHAFT INBOARD JOINT BOOT CLAMP |
| 8. INSTALL REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP |