Home › Power Source / Network › FA20 BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK ECM

C243567E03

  1. Measure the resistance, voltage and waveform according to the value(s) in the table below.

    Terminal No.
    (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A33-2 (BATT) - A34-1 (E03)
    W - B-R
    Battery power
    Always
    11 to 14 V
    A33-11 (IB) - A35-30 (EPA2)
    R-B - Y-B
    Battery current sensor
    Ignition switch ON
    0.5 to 4.5 V
    A33-24 (THB) - A35-30 (EPA2)
    R-W - Y-B
    Battery temperature sensor
    Ignition switch ON 20 to 50°C (68 to 122°F)
    1.1 to 2.4 V
    A34-1 (E03) - Body ground
    B-R - Body ground
    Body ground
    Always
    Below 1 Ω
    A35-18 (ALT) - A34-1 (E03)
    V - B-R
    Generator
    Idling with warm engine
    Pulse generation (See waveform 1)
    A35-22 (VCP2) - A35-30 (EPA2)
    G-B - Y-B
    Power source of battery current sensor assembly
    Ignition switch ON
    4.5 to 5.5 V
    If the result is not as specified, the ECU may have a malfunction.



  2. A266302E01
  3. WAVEFORM 1
    Generator 
    Tester Connection
    Tool Setting
    Vehicle Condition
    Specified Condition
    A35-18 (ALT) - A34-1 (E03)
    2 V/DIV., 2 msec./DIV.
    Idling with warm engine
    Correct waveform as shown in illustration

    HINT:
    1. The oscilloscope waveform shown in the illustration is an example for reference only. Noise, chattering, etc. are not shown.
    2. A constant value is not output, as the duty ratio varies depending on the electrical load and battery condition.