BRAKE MASTER CYLINDER (for RHD) > REMOVAL |
| 1. REMOVE FRONT WHEEL RH |
| 2. DRAIN BRAKE FLUID |
| 3. REMOVE FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY RH |
| 4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
Release the vacuum from the booster by depressing the brake pedal several times.
Disconnect the reservoir level switch connector.
![]() |
Using a union nut wrench 12, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.
![]() |
Disconnect the 2 harness wire clamps, and slide the harness wire to the upper of the vehicle.
![]() |
Remove the 2 nuts, and disconnect the brake master cylinder sub-assembly from the brake booster assembly.
| 5. REMOVE SEAL |
Remove the seal.