Home › Drivetrain ยท CLUTCH › CLUTCH MASTER CYLINDER (for RHD)

CLUTCH MASTER CYLINDER (for RHD) > DISASSEMBLY

for Preparation Click here



1. REMOVE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Remove the master cylinder reservoir cap.

  1. Fix the clutch master cylinder assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a pin punch and a hammer, tap out the straight pin and remove the master cylinder reservoir sub-assembly.



2. REMOVE CLUTCH RESERVOIR GROMMET
  1. Remove the clutch reservoir grommet from the clutch master cylinder assembly.



3. REMOVE MASTER CYLINDER PISTON SUB-ASSEMBLY


C261656
  1. Using snap ring pliers, remove the snap ring while pushing the clutch master cylinder push rod.

  1. Remove the master cylinder piston sub-assembly and spring from the cylinder body.

    NOTICE:
    Do not damage the inside of the cylinder body.