Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH

PARKING BRAKE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARKING BRAKE SWITCH ASSEMBLY


  1. Check the resistance.



      C230989
    1. Using an ohmmeter, measure the resistance between the terminals.
      Text in Illustration 
      V100135
      ON
      V100136
      OFF

      Standard resistance:

      Tester Connection
      Switch Condition
      Specified Condition
      1 - Ground
      Released (ON)
      Below 1 Ω
      1 - Ground
      Pushed in (OFF)
      10 kΩ or higher

      If the result is not as specified, replace the parking brake switch assembly.