Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



OUTLINE OF THEFT DETERRENT SYSTEM
  1. The theft deterrent system can be set by locking the doors using the transmitter.
  2. The alarm function will be activated when someone attempts to forcibly unlock any of the doors or open any of the doors and luggage compartment door while the system is in the armed state.
  3. In the alarm sounding state, the system illuminates the interior light and flashes the hazard warning lights. At the same time, the system sounds the vehicle horn to deter break-in and theft as well as to warn people around the vehicle.
  4. The alarm can be cancelled by unlocking the doors using the transmitter.
  5. The theft deterrent system has the active arming mode. There are 4 states; a disarmed state, an arming preparation state, an armed state, and an alarm sounding state.
  1. Disarmed state:

    1. The alarm function is not operating.
    2. The theft deterrent system is not operating.

  2. Arming preparation state:

    1. The time until the system goes into the armed state.
    2. The theft deterrent system is not operating.

  3. Armed state:

    1. The theft deterrent system is operating.

  4. Alarm sounding state:

    1. The alarm function is operating.

    Alarm time:
    Approximately 60 seconds.


    Alarm Method and Time 
    Alarm Method
    Hazard Warning Lights
    Flashing
    Interior Light
    Illuminating
    Vehicle Horns
    Sounding
    (approximately 0.4 second intervals)
    Alarm Time
    Approximately 60 seconds

    HINT:
    If any of the doors are unlocked when the key is not in the actuation area during the armed state, a forced door lock signal will be output.


FUNCTION OF MAIN COMPONENTS

Component
Function
Security indicator light
Informs driver of theft deterrent system status.
Hazard warning lights
Flash when attempted break-in or theft is detected.
Interior light
Comes on when attempted break-in or theft is detected.
Low pitched horn
High pitched horn
Sound when attempted break-in or theft is detected.
Door courtesy light switch
Detects door status (open or closed).
Door lock position switch
Detects door status (locked or unlocked).
Luggage compartment door courtesy switch
Detects luggage compartment door status (open or closed).
Certification ECU (smart key ECU assembly)
Receives wireless door lock/unlock signal.

ACTIVE ARMING MODE

HINT:
Active arming mode starts the alarm control immediately after the doors are locked.



  1. Active arming mode:
    This system operates as described in the diagram below when one of the items for each condition is met.


    B163417E22


    Condition
    Item
    Condition (1)
    All conditions are met:
    1. Engine switch off
    2. All doors are closed
    3. Luggage compartment door closed
    4. All doors locked by wireless, keyless lock* or entry door lock operation
    Condition (2)
    1. Allow approx. 30 seconds to elapse.
    Condition (3)
    Any conditions are met:
    1. All doors unlocked by wireless or entry unlock operation
    2. Any door is unlocked
    3. Any door is opened
    4. Push the engine switch
    5. Engine switch is turned on (ACC) or on (IG)
    6. The battery is reconnected.
    Condition (4)
    Any conditions are met:
    1. The luggage compartment door is opened when the luggage compartment door is closed.
    2. Any door is opened when all doors are closed.
    3. Any door is unlocked when all doors are locked.
    4. When 5 seconds or more have elapsed after the engine switch is turned off, the engine switch is turned to on (IG).
    5. The battery is reconnected.
    Condition (5)
    Any conditions are met:
    1. The state that the engine speed is 550 rpm or more continues for 2 seconds or more.
    2. All doors unlocked by wireless or entry unlock operation
    3. Engine switch is turned on (ACC) or on (IG)
    Condition (6)
    After approx. 60 seconds, alarm stops and system returns to armed state.
    Condition (7)
    The luggage compartment door is opened by wireless or entry luggage compartment door open operation.
    Condition (8)
    The luggage compartment door is closed when the luggage compartment door is opened.
    Condition (9)
    Any conditions are met:
    1. Any door is unlocked when all doors are locked.
    2. Any door is opened
    3. Push the engine switch
    4. Engine switch is turned on (ACC) or on (IG)
    5. All doors unlocked by wireless or entry unlock operation
    6. The battery is reconnected.
    Condition (10)
    All conditions are met:
    1. Engine switch off
    2. When all doors are closed and luggage compartment door is open, all doors are locked with wireless, keyless lock* or entry lock operation.
    Condition (11)
    Any conditions are met:
    1. Luggage compartment door closed
    2. Luggage compartment door opened through wireless or entry luggage compartment door open operation
    1. *: A keyless lock operation is when a door is locked by operating the door lock knob of an open door, and then closing the door while pulling the front door outside handle assembly.


FORCED DOOR LOCK CONTROL
  1. The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (alarm starts), all doors are forced to lock by a forced door lock signal.

    1. Conditions that force the doors to lock:
      Engine switch on (ACC or IG) position and both of the following conditions are met:

      1. The theft deterrent system is in the alarm sounding state of active arming mode.
      2. Any door is unlocked.

      HINT:
      1. During the first alarm, forced door lock control does not operate if any door is unlocked by key operation.
      2. After the first alarm, forced door lock control does operate.


SECURITY INDICATOR LIGHT OUTPUT
  1. The main body ECU (network gateway ECU) outputs a signal to turn on the security indicator light, according to the state of the theft deterrent system. However, some of the actual lighting conditions of the security indicator light are different from the output signals of the main body ECU (network gateway ECU).

    Output 
    State of Theft Deterrent System
    Security Indicator light
    Output Signal from Main Body ECU (Network Gateway ECU)
    Actual Lighting Condition
    Disarmed state (1), (2)
    OFF
    OFF (Immobiliser system unset)
    BLINKING (Immobiliser system set)
    Arming preparation state
    ON
    ON
    Armed state
    OFF
    BLINKING
    Alarm sounding state
    ON
    ON
    Blinking Cycle 
    Time
    Security Indicator light
    0.125 seconds.
    ON
    1.875 seconds.
    OFF