POWER STEERING SYSTEM > PRECAUTION |
| 1.IGNITION SWITCH EXPRESSIONS |
| Expression | Ignition Switch (position) | Engine Switch (condition) |
| Ignition Switch off | Off | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
| 2.HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM |
The vehicle is equipped with a Supplemental Restraint System (SRS). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.
Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for Supplemental Restraint System (Click here).
| 3.PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC MOTOR POWER STEERING COMPONENTS |
Be sure to align the front wheels straight ahead when removing and installing the power steering link assembly.
If disconnecting the steering intermediate shaft and pinion shaft of the power steering link assembly, be sure to place matchmarks before starting the operation.
If replacing the power steering ECU assembly, always replace it with a new one (if the power steering ECU assembly is not replaced with a new one, DTCs may be stored).
After replacing the steering column assembly or power steering ECU assembly, write the assist map, initialize the rotation angle sensor and calibrate the torque sensor zero point (Click here).
| 4.HANDLING PRECAUTION |
When handling electronic parts:
When handling the steering column assembly:
When disconnecting the connectors related to the power steering system, turn the ignition switch to ON, center the steering wheel, turn the ignition switch off, disconnect the negative (-) battery terminal, and then disconnect the connectors.
| 5.PRECAUTIONS FOR CAN COMMUNICATION |
Perform troubleshooting for the communication line problems when DTCs of the CAN communication system are output. Be sure to start troubleshooting the power steering system after confirming that the CAN communication system is normal.
Since the CAN communication line has a specific length and route, it cannot be repaired temporarily with a bypass wire, etc.