Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER STEERING ECU

C264066E01


Text in Illustration 
*a
Component without harness connected
(Power Steering ECU Assembly)
-
-

HINT:
As connector z1 uses a lock lever, each terminal cannot be checked while the connector is still connected to the power steering ECU.


Terminal No. (Symbol)
Terminal Description
z1-1 (V)
V phase motor output
z1-2 (U)
U phase motor output
z1-3 (W)
W phase motor output
  1. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A14-1 (PIG) - A14-2 (PGND)
    W - B
    Motor power supply
    Always
    9 to 16 V
    A14-2 (PGND) - Body ground
    B - Body ground
    Power ground
    Always
    Below 1 Ω
    A15-1 (CANH) - A15-7 (CANL)
    B - W
    CAN communication line
    Ignition switch off
    57 to 63 Ω
    A15-6 (IG) - A14-2 (PGND)
    G-W - B
    IG power supply
    Ignition switch ON
    9 to 16 V
    z2-5 (RZV) - A14-2 (PGND)
    R - B
    Rotation angle sensor excitation output signal
    Engine running, steering wheel being turned
    0.68 to 4.42 V
    z2-7 (RZG) - A14-2 (PGND)
    B - B
    Rotation angle sensor excitation circuit ground
    Always
    Below 1 Ω
    z2-13 (RZCS) - A14-2 (PGND)
    L - B
    Rotation angle sensor COS aspect input signal
    Engine running, steering wheel being turned
    0.68 to 4.42 V
    z2-14 (RZSN) - A14-2 (PGND)
    Y - B
    Rotation angle sensor SIN aspect input signal
    Engine running, steering wheel being turned
    0.68 to 4.42 V
    z2-8 (TRQ1) - z2-11 (TRQG)
    W - B
    Torque sensor signal 1
    Engine running, steering wheel not turned (without load)
    2.3 to 2.7 V
    Engine running, steering wheel turned to right with vehicle stopped
    2.3 to 3.8 V
    Engine running, steering wheel turned to left with vehicle stopped
    1.2 to 2.7 V
    z2-9 (TRQV) - z2-11 (TRQG)
    R - B
    Torque sensor power supply
    Ignition switch ON
    4.5 to 5.5 V
    z2-10 (TRQ2) - z2-11 (TRQG)
    Y - B
    Torque sensor signal 2
    Engine running, steering wheel not turned (without load)
    2.3 to 2.7 V
    Engine running, steering wheel turned to right with vehicle stopped
    1.2 to 2.7 V
    Engine running, steering wheel turned to left with vehicle stopped
    2.3 to 3.8 V
    z2-11 (TRQG) - Body ground
    B - Body ground
    Torque sensor ground
    Always
    Below 1 Ω
    If the result is not as specified, the ECU may have a malfunction.