POWER STEERING SYSTEM > CALIBRATION |
| ROTATION ANGLE SENSOR INITIALIZATION AND TORQUE SENSOR ZERO POINT CALIBRATION |
Inspection before calibration
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG Power Supply | ECU power source voltage/ Min.: 0 V Max.: 20.1531 V | 9 to 16 V | The ignition switch is ON. |
Rotation angle sensor initialization and torque sensor zero point calibration
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Utility / Torque Sensor Adjustment.
According to the display on the GTS, perform calibration.
| ASSIST MAP CONFIRMATION / CLEAR |
Check assist map
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Utility / Assist Map Confirmation / Clear.
Check that "MAP2" is displayed on the GTS screen.
Clear assist map
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Utility / Assist Map Confirmation / Clear.
Clear the assist map following the instructions on the GTS screen.
Start the engine.
Enter the following menus: Chassis / EMPS / Utility / Assist Map Confirmation / Clear.
Check that "MAP2" is displayed on the GTS screen.