Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If a problem occurs in the power steering system, the EPS warning light comes on in the combination meter and the power steering assist is stopped, locked at a particular point, or decreased simultaneously to protect the system.

Power Steering System 
DTC Code
Detection Condition
Fail-safe Operation
C1511
Torque sensor malfunction
Power assist stops.
C1512
C1513
C1514
C1515
C1516
C1517
C1521
Motor circuit malfunction
C1522
C1523
C1524
C1525
Motor rotation angle sensor malfunction
C1526
C1528
C1531
ECU malfunction
C1532
C1533
Assist force is restricted.
C1534
C1541
Skid control malfunction
The amount of power assist is locked at the 100 km/h (62 mph) level of power assist.
C1551
IG power supply voltage error
Power assist stops.
C1552
PIG power supply voltage error
C1554
Power supply relay malfunction
C1555
Motor relay malfunction
C1581
Assist map not written in power steering ECU
Control is performed using the default settings.
C1582
Assist map mismatch in power steering ECU
Control is performed using the current assist map.
U0100
ECM communication error
Power assist continues as normal*1.
Power assist stops*2.
U0122
Skid control ECU communication error
The amount of power assist is locked at the 100 km/h (62 mph) level of power assist.
U0416

HINT:
  1. *1: When the DTC is stored while the engine is running.
  2. *2: When the DTC is stored before the engine is started.
  3. The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.
  4. If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist is reduced and the EPS warning light comes on. In such cases, the amount of power assist returns normal when the battery voltage recovers.