Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1551    IG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU assembly determines whether the ignition switch status is ON or off through the IG power supply circuit.

DTC Code
DTC Detection Condition
Trouble Area
C1551
An IG power supply circuit malfunction inside the ECU
  1. ECU IG1 fuse
  2. IG power supply circuit
  3. Power steering ECU assembly

WIRING DIAGRAM


C113532E55


INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING GTS (IG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / EMPS / Data List.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG Power Supply
    ECU power source voltage/
    Min.: 0.0000 V
    Max.: 20.1531 V
    9 to 16 V
    The ignition switch is ON.

    OK:
    The normal condition value is displayed the GTS.



NG
Go to step 2
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BATTERY/BODY GROUND)


    C198250E04
  1. Disconnect the A14 and A15 power steering ECU assembly connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A15-6 (IG) - Body ground
    Ignition switch ON
    9 to 16 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A14-2 (PGND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Power Steering ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)