Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1552    PIG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

When a problem occurs in the power steering system, the power supply relay circuit is shut off to stop the power assist.

DTC Code
DTC Detection Condition
Trouble Area
C1552
A PIG power supply circuit malfunction inside the ECU
  1. EPS fuse
  2. PIG power supply circuit
  3. Power steering ECU assembly

WIRING DIAGRAM


C261871E01


INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.READ VALUE USING GTS (PIG POWER SUPPLY)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Start the engine.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / EMPS / Data List.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PIG Power Supply
    Power source voltage to active motor/
    Min.: 0.0000 V
    Max.: 20.1531 V
    9 to 16 V
    The engine is running and power steering is operating.

    OK:
    The normal condition value is displayed the GTS.



NG
Go to step 2
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BATTERY/BODY GROUND)


    C198251E04
  1. Disconnect the A14 power steering ECU assembly connector .

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A14-1 (PIG) - Body ground
    Always
    9 to 16 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A14-2 (PGND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Power Steering ECU Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)