Home › Vehicle Exterior › WINDOW / GLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH

FRONT PASSENGER SIDE POWER WINDOW SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicle.
  2. The procedure listed below is for the LHD vehicle.



1. REMOVE DOOR ARMREST COVER RH

HINT:
Use the same procedure as for the LH side .



2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    B314155
  1. Remove the 4 screws and power window regulator switch assembly with front door armrest base panel.



4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B359229E03
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the power window regulator switch assembly.
    Text in Illustration 
    *1
    Protective Tape