Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT

INPUT SHAFT > DISASSEMBLY

for Preparation Click here



1. INSPECT NEEDLE ROLLER BEARING


    C257051
  1. Install the input shaft to the output shaft, and then check the needle roller bearing.

    Standard:
    Abnormal fitting, interfering, abnormal noise, or looseness should not be found.

    HINT:
    If any abnormality is found, replace the needle roller bearing with a new one.



2. INSPECT RADIAL CLEARANCE


    C257052
  1. Install the input shaft to the output shaft, and then using a dial indicator, measure the radial clearance.

    Standard clearance:
    0.029 to 0.072 mm (0.00114 to 0.00283 in.)

    Maximum clearance:
    0.072 mm (0.00283 in.)

    HINT:
    If the clearance exceeds the maximum, replace the needle roller bearing and output shaft with a new ones.



3. INSPECT FRONT INPUT SHAFT BEARING


    C257050
  1. Check the front input shaft bearing.

    Standard:
    Abnormal fitting, interfering, abnormal noise, or looseness should not be found.

    HINT:
    If any abnormality is found, replace the front input shaft bearing with a new one.



4. REMOVE NEEDLE ROLLER BEARING


    C266542
  1. Remove the needle roller bearing from the input shaft.



5. REMOVE NO. 2 SYNCHRONIZER RING


    C266543
  1. Remove the No. 2 synchronizer ring from the input shaft.



6. REMOVE FRONT INPUT SHAFT BEARING


    C257053
  1. Using 2 screwdrivers and a hammer, remove the shaft snap ring from the input shaft.

    NOTICE:
    Use a cloth to prevent the shaft snap ring from popping out.



    C257054E01
  1. Using SST and a press, remove the front input shaft bearing from the input shaft.

    SST
    09950-00020