Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT

INPUT SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT INPUT SHAFT BEARING


    C266540E01
  1. Using SST and a press, as shown in the illustration, install a new front input shaft bearing to the input shaft.
    Text in Illustration 
    *1
    Front Input Shaft Bearing
    V100135
    Front Side

    SST
    09527-20011  
    09950-60010   (09951-00560)

    NOTICE:
    Retain the front input shaft bearing inner race, and press fit.



    C257056
  1. Select a shaft snap ring that is suitable to retain the specific thrust clearance between the front input shaft bearing and shaft snap ring.

    Standard clearance:
    0 mm (0 in.)

    Maximum clearance:
    0.1 mm (0.00394 in.)

    Shaft Snap Ring Thickness 
    Part No.
    Thickness mm (in.)
    Mark
    SU003-03575
    1.95 (0.07677)
    0
    SU003-03576
    2.00 (0.07874)
    1
    SU003-03577
    2.05 (0.08070)
    2
    SU003-03578
    2.10 (0.08267)
    3
    SU003-03579
    2.15 (0.08464)
    4
    SU003-03580
    2.20 (0.08661)
    5

  1. Using a brass bar and a hammer, install a new shaft snap ring to the input shaft.



2. INSTALL NO. 2 SYNCHRONIZER RING


    C266543
  1. Apply manual transmission gear oil to the No. 2 synchronizer ring, and then install the No. 2 synchronizer ring to the input shaft.



3. INSTALL NEEDLE ROLLER BEARING


    C266542
  1. Apply manual transmission gear oil to the needle roller bearing, and then install the needle roller bearing to the input shaft.