REFRIGERANT (for HFO-1234yf(R1234yf)) > PRECAUTION |
| 1.PRECAUTIONS FOR REFRIGERANT HFO-1234yf (R1234yf) |
Compatibility
The parts used in the refrigerant cycle, the compressor oil, etc. of the HFO-1234yf (R1234yf) system are not compatible with the conventional HFC-134a (R134a) system.
HFO-1234yf (R1234yf) Refrigerant
Always use HFO-1234yf (R1234yf) as the refrigerant.
Compressor Oil
Always use ND-OIL 12 as the compressor oil.
When parts of the air conditioning system are removed, quickly block off any areas that are exposed to the outside air with plugs, vinyl tape, etc., as the oil used for HFO-1234yf (R1234yf) systems absorbs moisture easily.
Do not allow the compressor oil to splash, as the oil used for HFO-1234yf (R1234yf) systems has harmful effects on acrylic resins.
Evacuation
When evacuating the system, be sure to use a refrigerant recovery unit, refrigerant recycler and refrigerant charger that are compatible with HFO-1234yf (R1234yf) systems.
Refrigerant Gas Leak Inspection
Use a gas leak detector to check for refrigerant gas leaks.
Turn the ignition switch off when checking for refrigerant leaks.
| 2.PRECAUTIONS RELATED TO REMOVAL AND INSTALLATION OF PARTS |
In case refrigerant gets in your eyes
Do not rub your eyes with your hands or a handkerchief.
Consult an eye doctor.
Handling of Refrigerant (Container)
Do not heat the container. If the container is directly heated or put into boiling water, the pressure inside the can will become abnormally high and the can may burst.
Do not drop or strike the container.
Do not bring the container anywhere near your face. Also, always wear eye protection.
Pipe Installation
Always use new O-rings.
Apply a sufficient amount of compressor oil (ND-OIL 12) to the O-ring.
Route the hoses in the way they are naturally shaped. Do not twist or forcibly bend the hoses.
Do not use cloth gloves, etc. as fibers attached to O-rings can lead to refrigerant gas leaks.