Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  3. If the problem only occurs in certain locations or at certain times of day, check for wave interference.
  4. If the vehicle components are added, check for wave interference from the added components.


Engine Immobiliser System 
Symptom
Suspected Area
See page
Engine cannot be started*1
Certification ECU (smart key ECU assembly)
-
Engine cannot be started*2
ID code box (immobiliser code ECU)*1
Click here
ECM
Click here
SFI system
Click here
Power source mode cannot be changed*2
Engine switch
Click here
Certification ECU (smart key ECU assembly)
Click here
Steering lock lock/unlock not possible*3
Steering lock actuator assembly (steering lock ECU)
Click here
  1. *1: w/ ID Code Box
  2. *2: Refer to Problem Symptoms Table for Entry and Start System (for Start Function) (Click here).
  3. *3: Refer to Problem Symptoms Table for Steering Lock System (Click here).