Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY LH


    B299993
  1. Remove the bolt.

  1. Disengage the hook and remove the separate type rear seat cushion assembly LH.



2. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B315203
  1. Remove the front door opening trim weatherstrip LH.



4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE FRONT DOOR SCUFF PLATE LH


    B315201
  1. Disengage the 6 claws and remove the front door scuff plate LH.



6. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.



7. SEPARATE LUGGAGE COMPARTMENT INNER TRIM COVER LH


    B321716
  1. Fold down the bench type rear seatback assembly.

  1. Disengage the 2 clips and disconnect the luggage compartment inner trim cover LH.



8. SEPARATE LUGGAGE COMPARTMENT INNER TRIM COVER RH

HINT:
Use the same procedure described for the LH side.



9. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH


    B315207
  1. Pull up the rear seatback assembly.

  1. Remove the clip.

  1. Disengage the 8 clips and remove the luggage compartment trim cover LH.



10. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

HINT:
Use the same procedure described for the LH side.



11. REMOVE QUARTER TRIM LID SUB-ASSEMBLY LH


    B315208
  1. Along the arrow in the illustration, disengage the 6 claws.



    B315209
  1. Disengage the 2 clips and 2 guides.

    HINT:
    Make the quarter trim lid sub-assembly LH hang down from the lid cover clip.



    B316678E01
  1. Push the lid cover clip knobs in the direction of the arrow to remove the 2 lid cover clips along with the quarter trim lid sub-assembly LH.
    Text in Illustration 
    *1
    Lid Cover Clip

  1. Remove the 2 lid cover clips from the lid cover LH.

    NOTICE:
    If there is any damage, be sure to replace the lid cover clip with a new one.



12. REMOVE QUARTER TRIM LID SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



13. REMOVE REAR WINDOW SIDE GARNISH LH


    B315213
  1. Remove the bolt.

  1. Disengage the 2 clips and guide remove the rear window side garnish LH.



14. REMOVE REAR WINDOW SIDE GARNISH RH

HINT:
Use the same procedure described for the LH side.



15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    E247224
  1. Disconnect the connector.



    E247225
  1. Remove the 4 clips.



    E247226
  1. Disengage the 4 clips and remove the package tray trim panel assembly with the center stop light assembly.



16. REMOVE TIRE PRESSURE WARNING RECEIVER


    E285802
  1. Disconnect the connector.

  1. Remove the bolt.

  1. Disengage the guide and remove the tire pressure warning receiver.

    NOTICE:
    1. Do not drop the tire pressure warning receiver or apply impact on it.
    2. When replacing or inspecting the tire pressure warning receiver, do not change the wiring route or the length of the harness around the receiver.