Home › Engine / Hybrid System › FA20 ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
  1. Apply a light coat of engine oil to the new O-ring of the VVT sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Connect the VVT sensor connector.



2. INSTALL NO. 1 ENGINE UNDER COVER


    A280546
  1. Install the No. 1 engine under cover with the 12 bolts and engage the 7 clips.
    V100135
    Bolt A
    V100136
    Bolt B

    Torque:
    Bolt A:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }
    Bolt B:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



3. INSTALL VVT SENSOR (for Intake Side of Bank 2)
  1. Apply a light coat of engine oil to the new O-ring of the VVT sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Connect the VVT sensor connector



4. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)
  1. Apply a light coat of engine oil to the new O-ring of the VVT sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Connect the VVT sensor connector.



5. INSTALL VVT SENSOR (for Intake Side of Bank 1)
  1. Apply a light coat of engine oil to the new O-ring of the VVT sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

  1. Connect the VVT sensor connector.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL