Home › Engine / Hybrid System › FA20 ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL



2. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    A276530
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor.

  1. Remove the O-ring from the VVT sensor.



3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    A276532
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor.

  1. Remove the O-ring from the VVT sensor.



4. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    A276529
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor.

  1. Remove the O-ring from the VVT sensor.



5. REMOVE NO. 1 ENGINE UNDER COVER


    A278294
  1. Disengage the 7 clips and remove the 12 bolts and No. 1 engine under cover.



6. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    A276531
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt and VVT sensor.

  1. Remove the O-ring from the VVT sensor.