Home › Engine / Hybrid System › FA20 ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CRANKSHAFT POSITION SENSOR


    A280261E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    1836 to 2244 Ω

    Text in Illustration 
    *a
    Component without harness connected:
    (Crankshaft Position Sensor)
    If the resistance is not as specified, replace the crankshaft position sensor.