Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RHD and LHD vehicle.
  2. The procedure listed below is for the LHD vehicle.



1. REMOVE FRONT CONSOLE BOX COVER
  1. Move the shift lever to N.



    B316857E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B316858
    B320022E01
  1. Disengage the 6 claws and remove the front console box cover.

    HINT:
    Hold the engine switch area and the inside of the pocket with your hand, and pull off the front console box cover.

    HINT:
    Remove the instrument panel finish panel end RH, and then push the reverse side of the front console box cover with a bar (tool handle, etc.) to remove it.

    Text in Illustration 
    *1
    Bar

    NOTICE:
    Do not push the switches or the antenna with the bar (tool handle, etc.).

  1. Disconnect each connector.



2. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR


    B313002
  1. Disengage the clamp and remove the indoor electrical key oscillator.