Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR

POWER WINDOW REGULATOR MOTOR > INSPECTION

for Preparation Click here


HINT:
Use the same procedure for the LHD and RHD vehicles.



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    B292925E01
  1. Check the operation of the power window regulator motor assembly RH.

    NOTICE:
    Do not apply positive (+) battery voltage to any terminals other than terminal 1 or 3 to avoid damaging the pulse sensor inside the motor.


    1. Apply battery voltage to the power window regulator motor assembly RH and check the operation of the power window regulator motor assembly RH.

  1. Check that the motor gear rotates smoothly as follows:

    Standard:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) → Terminal 3 (WD)
    2. Battery negative (-) → Terminals 1 (WU)
    Motor gear rotates clockwise
    1. Battery positive (+) → Terminal 1 (WU)
    2. Battery negative (-) → Terminals 3 (WD)
    Motor gear rotates counterclockwise

    Text in Illustration 
    *1
    Motor Gear
    *a
    Clockwise
    *b
    Counterclockwise
    *c
    Component without harness connected
    (Power Window Regulator Motor Assembly RH)
    1. If the result is not as specified, replace the power window regulator motor assembly RH.

    CAUTION:
    Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.



2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B312537E01
  1. Check the operation of the power window regulator motor assembly LH.

    NOTICE:
    Do not apply positive (+) battery voltage to any terminals other than terminal 1 or 3 to avoid damaging the pulse sensor inside the motor.


    1. Apply battery voltage to the power window regulator motor assembly LH and check the operation of the power window regulator motor assembly LH.

  1. Check that the motor gear rotates smoothly as follows:

    Standard:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) → Terminal 3 (WD)
    2. Battery negative (-) → Terminals 1 (WU)
    Motor gear rotates counterclockwise
    1. Battery positive (+) → Terminal 1 (WU)
    2. Battery negative (-) → Terminals 3 (WD)
    Motor gear rotates clockwise

    Text in Illustration 
    *1
    Motor Gear
    *a
    Counterclockwise
    *b
    Clockwise
    *c
    Component without harness connected
    (Power Window Regulator Motor Assembly LH)
    1. If the result is not as specified, replace the power window regulator motor assembly LH.

    CAUTION:
    Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.