Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > OPERATION CHECK

for Preparation Click here



INSPECT INTERIOR LIGHT CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The interior light control illuminates the lights below.
  1. Engine Switch Illumination*1
  2. Ignition Key Cylinder Light*2
  3. Map Light

  1. The operation and conditions of this control are described below.

    Operation
    Condition
    Fade in and illuminate constantly
    Any door is opened when all doors are closed.
    Illuminate for 15 seconds, and then fade out
    When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
    1. The key enters any actuation area around the doors when the engine switch is off and all doors are closed(*1,*3).
    2. Any door is unlocked when the ignition switch is off with all doors closed and locked.
    3. The ignition switch is turned from ON to off when all doors are closed.
    4. All doors are closed after any door is opened and the ignition switch off.
    Fade out immediately
    When any of the following conditions is met, the lights fade out immediately:
    1. The ignition switch is turned from off to ACC when all doors are closed.
    2. All doors are locked when the ignition switch is off, all doors are closed and any door is unlocked.
    3. All doors are locked again when all doors are already closed and locked.

    1. *1: w/ Entry and Start System
    2. *2: w/o Entry and Start System
    3. *3: When the lights are on, if the key leaves all of the actuation areas around the doors, after approximately 3 seconds, the lights fade out.


BATTERY SAVING CONTROL OPERATION

NOTICE:
Perform this inspection with the customize parameters at the initial settings.

HINT:
The lights controlled by battery saving control are as follows:
  1. Engine Switch Illumination*1
  2. Ignition Key Cylinder Light*2
  3. Map Light
  4. Courtesy Light
  5. Luggage Compartment Light
  6. Vanity Light

  1. The operation and conditions of this control are described below.

    Operation
    Condition
    Battery saving
    When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.

    HINT:
    Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
    1. The ignition switch is turned ACC or ON
    2. Any door is opened and closed
    3. The luggage compartment door is opened and closed
    4. Any door is unlocked
    5. The key enters any exterior actuation area

    1. *1: w/ Entry and Start System
    2. *2: w/o Entry and Start System