Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B1577    Immobiliser System EEPROM Malfunction

for Preparation Click here


DESCRIPTION

The ECM stores this code when an internal malfunction is detected in the certification ECU (smart key ECU assembly) or when the ROM in the certification ECU (smart key ECU assembly) cannot be accessed.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B1577
  1. Internal malfunction in the certification ECU (smart key ECU assembly) (1 trip detection logic*).
  2. When the ROM in the certification ECU (smart key ECU assembly) cannot be accessed (1 trip detection logic*).
Certification ECU (smart key ECU assembly)
Check for DTCs.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
Engine switch on (IG)

Related Data List and Active Test 
DTC Code
Data List and Active Test
B1577
-

INSPECTION PROCEDURE

NOTICE:
  1. Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) (Click here).
  2. After repair, confirm that no DTCs are output by performing the "DTC Output Confirmation Operation".

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

OK:
DTC B1577 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END