Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    U0073    Control Module Communication Bus "A" Off

DTC    U0101    Lost Communication with TCM

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

DTC    U0155    Lost Communication with Instrument Panel Cluster (IPC) Control Module

DTC    U0402    Invalid Data Received from TCM

DTC    U0416    Invalid Data Received from Vehicle Dynamics Control Module

DTC    U0423    Invalid Data Received from Instrument Panel Cluster Control Module

for Preparation Click here


DESCRIPTION

The ECM communicates several signals with each sensor and ECU by CAN communication circuit.
There are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

DTC Code
DTC Detection Condition
Trouble Area
U0073
Bus off state for 0.436 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. ECM
U0101
No communication between ECM and TCM for 0.5 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. TCM
  3. ECM
U0122
No communication between ECM and skid control ECU for 0.5 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. Skid control ECU (Brake actuator assembly)
  3. ECM
U0155
No communication between ECM and combination meter assembly for 0.5 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. Combination meter assembly
  3. ECM
U0402
Invalid data received from TCM for 2 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. TCM
  3. ECM
U0416
Invalid data received from skid control ECU for 2 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. Skid control ECU (Brake actuator assembly)
  3. ECM
U0423
Invalid data received from combination meter assembly for 2 seconds or more
(1 trip detection logic)
  1. Wire harness (CANL and CANH circuits)
  2. Combination meter assembly
  3. ECM

INSPECTION PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.

  1. Read the DTCs.

    Result:

    Result
    Proceed to
    DTC U0073, U0101, U0122, U0155, U0402, U0416 or U0423 is output
    A
    DTC U0073, U0101, U0122, U0155, U0402, U0416 or U0423 and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)