Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR

WASHER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
  1. Disconnect the front washer motor and pump assembly connector.

    HINT:
    Make sure that the front washer motor and pump assembly is installed to the washer jar.

  1. Fill the washer jar with windshield washer fluid.



    E132855E06
  1. Check that the windshield washer fluid flows from the washer jar.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Windshield washer fluid flows from the washer jar

    Text in Illustration 
    *a
    Component without harness connected
    (Windshield Washer Motor and Pump Assembly)
    If the result is not as specified, replace the windshield washer motor and pump assembly.