Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY

HEADLIGHT CLEANER CONTROL RELAY > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER CONTROL RELAY


E186708E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    6 (WRWA) - 4 (WF)
    Battery voltage not applied
    10 kΩ or higher
    Battery positive (+) → 3 (H)
    Battery negative (-) → 4 (WF)
    Battery negative (-) → 5 (E)
    Battery positive (+) → 3 (H)
    Battery negative (-) → 2 (PB)
    Battery negative (-) → 4 (WF)
    Below 1 Ω for 0.6 to 1.0 seconds, then resistance increases by a large amount
    Battery positive (+) → 3 (H)
    Battery negative (-) → 1 (IG)
    Battery negative (-) → 4 (WF)
    Battery negative (-) → 5 (E)

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Cleaner Control Relay)
    If the result is not as specified, replace the headlight cleaner switch assembly.