CONDENSER > INSTALLATION |
| 1. INSTALL COOLER CONDENSER ASSEMBLY |
Install the cooler condenser assembly with the 4 bolts.
Connect the external air temperature sensor clamp and connector.
| 2. CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY |
Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
Install the O-ring on the air conditioner tube and accessory assembly.
Install the air conditioner tube and accessory assembly on the cooler condenser assembly with the bolt.
| 3. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Install the O-ring on the No. 1 cooler refrigerant discharge hose.
Install the No. 1 cooler refrigerant discharge hose on the cooler condenser assembly with the bolt.
| 4. INSTALL FRONT BUMPER COVER |
| 5. CHARGE WITH REFRIGERANT |
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
| 6. WARM UP ENGINE |
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
| 7. INSPECT FOR REFRIGERANT LEAK |
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):