Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR

ROOM TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
The power window system utilizes a mechanism in which the door glass moves down slightly when the door is opened, and in which the glass moves up when the door closed in order to prevent the door molding from being damaged. When the negative (-) battery terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



3. REMOVE LOWER INSTRUMENT PANEL (for LHD)
(Click here)


4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)


  1. for LHD

    1. Remove the screw.



    2. E252256
    3. Disengage the 3 claws and 4 clips and remove the No. 2 instrument panel under cover sub-assembly .



    E252255
  1. for RHD

    1. Remove the screw.

    2. Disengage the 3 claws and 4 clips.

    3. Disconnect the cooler thermistor hose and connector and remove the No. 2 instrument panel under cover sub-assembly .



5. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR (for RHD)


    E257023
  1. Disengage the 2 claws and remove the cooler (room temp. sensor) thermistor.



6. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR (for LHD)

HINT:
Use the same procedure described for the RHD.