Home › Vehicle Exterior › LIGHTING (EXT) › FRONT TURN SIGNAL LIGHT ASSEMBLY

FRONT TURN SIGNAL LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT TURN SIGNAL LIGHT SOCKET (w/ Side Marker Light)


    E252497E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard:
    Condition
    Specified Condition
    Battery positive (+) → 2
    Battery negative (-) → 4
    Clearance light comes on
    Battery positive (+) → 1
    Battery negative (-) → 4
    Turn signal light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Front Turn Signal Light Socket)
    If the result is not as specified, replace the bulb or the front turn signal light socket.



2. INSPECT FRONT TURN SIGNAL LIGHT SOCKET (w/o Side Marker Light)


  1. for Halogen Headlight



      E252497E01
    1. Measure the voltage according to the value(s) in the table below.

      Standard:
      Condition
      Specified Condition
      Battery positive (+) → 1
      Battery negative (-) → 4
      Turn signal light comes on
      Battery positive (+) → 3
      Battery negative (-) → 4
      Fog light comes on

  1. for HID Headlight

    1. Measure the voltage according to the value(s) in the table below.

      Standard:
      Condition
      Specified Condition
      Battery positive (+) → 1
      Battery negative (-) → 4
      Fog light comes on
      Battery positive (+) → 3
      Battery negative (-) → 4
      Turn signal light comes on

  1. w/ Daytime Running Light

    1. Measure the voltage according to the value(s) in the table below.

      Standard:
      Condition
      Specified Condition
      Battery positive (+) → 2
      Battery negative (-) → 4
      Daytime Running light comes on

      Text in Illustration 
      *a
      Component without harness connected
      (Front Turn Signal Light Socket)
      If the result is not as specified, replace the bulb or the front turn signal light socket.