FRONT SEAT CUSHION HEATER > INSTALLATION |
| 1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD (FRONT SEAT CUSHION HEATER ASSEMBLY) |
![]() |
Using hog ring pliers, install the separate type front seat cushion pad to the separate type front seat cushion cover with 12 new hog rings.
| *1 | Hog Ring |
| *2 | Hog Ring Pliers |
![]() |
Using hog ring pliers, install 2 new hog rings.
| *1 | Hog Ring |
| *2 | Hog Ring Pliers |
| 2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD |
Temporarily install the separate type front seat cushion cover with pad to the separate type front seat cushion spring assembly
Engage each hook.
Engage the claw and 3 clamps to install the front seat cushion heater wire harness. (w/ Seat Heater System)
Connect the occupant classification sensor connector. (for Front Passenger Side)
| 3. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY |
Using a T40 "TORX" socket wrench, install the separate type front seatback assembly and No. 2 front seat travel link with 4 new bolts.
Install a new washer (for Fold Down Seat Type).
Engage the claw and 4 clamps to install the front seat airbag assembly wire harness.
Engage the fastener to secure the front seat airbag assembly wire harness.
Engage the clamp and connect the front seat heater connector. (w/ Seat Heater System)
Connect the rubber band of the separate type front seatback cover.
Engage the 2 hooks.
| 4. INSTALL FRONT SEAT INNER CUSHION SHIELD |
Engage the 2 claws and 4 guides to install the front seat inner cushion shield.
| 5. INSTALL FRONT SEAT CUSHION SHIELD |
Engage the 4 claws, 5 guides and clip to install the front seat inner cushion shield.
Install the 2 screws.
| 6. INSTALL SEAT ADJUSTER COVER CAP |
Engage the 3 claws to install the seat adjuster cover cap.
| 7. INSTALL VERTICAL ADJUSTING HANDLE (for Driver Side) |
Install the vertical adjusting handle with the screw.
| 8. INSTALL RECLINING ADJUSTER RELEASE HANDLE |
Engage the claw to install the reclining adjuster release handle.
| 9. INSTALL FRONT SEAT ASSEMBLY |