Home › Engine / Hybrid System › FA20 STARTING › ENGINE SWITCH

ENGINE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT ENGINE SWITCH


    A280257E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (SSW1) - 6 (AGND)
    Pushed
    Below 1 Ω
    1 (SSW2) - 6 (AGND)
    Pushed
    Below 1 Ω
    5 (SSW1) - 6 (AGND)
    Not pushed
    10 kΩ or higher
    1 (SSW2) - 6 (AGND)
    Not pushed
    10 kΩ or higher

    If the result is not as specified, replace the engine switch.

  1. Apply battery voltage to the terminals of the switch and check the illumination condition of the switch.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 9 (SWIL)
    Battery negative (-) → Terminal 6 (AGND)
    Illuminates

    If the result is not as specified, replace the engine switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Engine Switch)