Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSMISSION OIL

MANUAL TRANSMISSION OIL > REPLACEMENT

for Preparation Click here



1. DRAIN MANUAL TRANSMISSION OIL


C261063
  1. Remove the manual transmission filler plug and the gasket.

  1. Remove the manual transmission drain plug and gasket, and then drain the manual transaxle oil.

  1. Install a new gasket and the manual transmission drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. ADD MANUAL TRANSMISSION OIL


    D025304E50
  1. Add manual transmission oil until the oil level is within 5 mm (0.197 in.) from the bottom of the manual transmission filler plug opening.
    Text in Illustration 
    *a
    0 to 5 mm (0 to 0.197 in.)

    Manual Transmission Gear Oil:
    Oil Grade:
    API GL-3 or API GL-4
    Viscosity:
    SAE 75W-90
    Standard Capacity (Reference):
    2.2 liters (2.3 US qts, 1.9 Imp. qts)

  1. Check for oil leakage when the oil level is low.

  1. Install the transmission filler plug and a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



3. INSPECT FOR MANUAL TRANSMISSION OIL
  1. Stop the vehicle in a level place.



    C257296
  1. Remove the manual transmission filler plug and the gasket.



    D025304E50
  1. Check that the oil surface is within 5 mm (0.197 in.) of the bottom of the manual transmission filler plug opening.
    Text in Illustration 
    *a
    0 to 5 mm (0 to 0.197 in.)

    NOTICE:
    1. Excessively large or small amounts of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. Check for oil leakage when the oil level is low.

  1. Install the manual transmission filler plug and a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



4. INSPECT FOR MANUAL TRANSMISSION OIL LEAK