Home › Engine / Hybrid System › FA20 LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
The power window system utilizes a mechanism in which the door glass moves down slightly when the door is opened, and in which the glass moves up when the door closed in order to prevent the door molding from being damaged. When the negative (-) battery terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A283417
  1. Loosen the hose clamp and disconnect the No. 2 ventilation hose.



    A283418
  1. Disconnect the mass air flow meter connector.

  1. Disengage the clamp and separate the wire harness from the air cleaner cap.



    A283419
  1. Loosen the 2 hose clamps.



    A283420
  1. Remove the 3 bolts and the air cleaner cap with air cleaner hose.



3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the engine oil pressure switch connector.



    A276917E01
  1. Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.
    Text in Illustration 
    *1
    24 mm Deep Socket Wrench