Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM

WINDOW DEFOGGER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the ignition switch to ON.

  4. Enter the following menus: Body Electrical / (desired system) / Data List.

  5. According to the display on the GTS, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Rear Defogger
    Status of rear defogger operation / Normal or Continuance*
    Normal: Turn off after approximately 15 minutes
    Continuance: Approximately 15 minutes and stops for 2 minutes, and that these operations repeat*
    -
    Rear Defogger SW
    Status of rear defogger SW operation / ON or OFF
    -
    -
    Rear Defogger Output
    Status of rear defogger output operation / ON or OFF
    -
    -

    1. *: for Automatic Air Conditioning System

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Defogger Relay (Rear)
    Status of rear defogger relay output operation / ON or OFF
    -
    -


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. According to the display on the GTS, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Rear Defogger
    DEF relay
    ON/OFF
    -