Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH

UNLOCK WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT UN-LOCK WARNING SWITCH ASSEMBLY


B225713E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (UN+) - 2 (UN-)
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1 Ω

    If the result is not as specified, replace the un-lock warning switch assembly.
    Text in Illustration 
    *1
    Pin
    *a
    Component without harness connected
    (Un-lock Warning Switch Assembly)