UNLOCK WARNING SWITCH > REMOVAL |
| 1. REMOVE INSTRUMENT SIDE PANEL LH |
| 2. REMOVE INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel) |
![]() |
Using a moulding remover, disengage the 8 clips and 2 claws to remove the instrument panel ornament.
| *1 | Moulding Remover |
| 3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel) |
![]() |
Using a moulding remover, disengage the 2 claws and 4 clips to remove the center instrument cluster finish panel sub-assembly.
| *1 | Moulding Remover |
| 4. REMOVE METER HOOD SUB-ASSEMBLY |
![]() |
Remove the screw.
Disengage the 12 claws, and then pull out the meter hood sub-assembly diagonally upwards to remove it.
| 5. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT |
![]() |
Disengage the 6 claws and 2 clips.
![]() |
Disengage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.
Disconnect the connector and remove the upper instrument panel meter ornament.
| 6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag) |
![]() |
Remove the 2 screws.
![]() |
Disengage the 4 clips.
Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.
![]() |
w/ Automatic Air Conditioning System for RHD:
Disengage the guide and disconnect the aspirator hose.
Disconnect the connector.
Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
| *1 | Aspirator Hose |
| 7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag) |
![]() |
Remove the screw.
![]() |
Disengage the 6 clips.
Disengage the 2 claws and separate the No. 1 instrument panel under cover sub-assembly.
Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
| 8. REMOVE LOWER STEERING COLUMN COVER |
![]() |
While turning the steering wheel assembly to the right and left, remove the 2 screws.
![]() |
w/ Knee Airbag
Disengage the 4 claws and remove the lower steering column cover.
![]() |
w/o Knee Airbag
Disengage the 6 claws and remove the lower steering column cover.
| 9. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the 2 claws and remove the upper steering column cover.
| 10. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY |
![]() |
Disconnect the un-lock warning switch assembly connector.
Detach the 2 claws and remove the un-lock warning switch assembly.