Home › General › SPECIFICATIONS › ALIGNMENT / HANDLING DIAGNOSIS

ALIGNMENT / HANDLING DIAGNOSIS > SERVICE DATA



Vehicle Height (Unloaded Vehicle) 
Front B - A
Rear C
Rear D
Rear E
146 mm (5.75 in.)
225 mm (8.86 in.)
375 mm (14.76 in.)
372 mm (14.65 in.)
Measurement points:
  1. A: Ground clearance of front lower suspension arm set front bolt center
  1. B: Ground clearance of front wheel center
  1. C: Ground clearance of lower control arm set bolt center
  1. D: Front wheel arch height of front wheel center
  1. E: Rear wheel arch height of rear wheel center

Camber (Unloaded Vehicle) 
-
Camber Inclination
Right-left Difference
Front
0 +/- 45' (0 +/- 0.75°)
30' (0.50°) or less
Rear
-1°12' +/- 45' (-1.20° +/- 0.75°)
45' (0.75°) or less

Caster (Unloaded Vehicle) 
-
Caster Inclination (Reference)
Right-left Difference
Front
5°54' (5.90°)
30' (0.50°) or less

Wheel Turning Angle (Unloaded Vehicle) 
-
Inside Wheel (Reference)
Outside Wheel (Reference)
Front
36°54' (43.90°)
31°12' (31.20°)

Toe-in (Unloaded Vehicle) 
-
Specified Condition
Front
C + D: 0°00' +/- 0°11' (0.00° +/- 0.19°)
B - A: 0 +/- 3.0 mm (0 +/- 0.1181 in.)
Rear
C + D: 0°10' +/- 0°15' (0.16° +/- 0.24°)
B - A: 2.0 +/- 3.0 mm(0.0787 +/- 0.1181 in.)

Wheel Turning Angle (Unloaded Vehicle) 
-
Inside Wheel
Outside Wheel Reference
Front
41°48' +/- 2°(41.8° +/- 2°)
36°20' (36.33°)

Distance between the centers of the 2 installation bolts of the rear No. 2 suspension arm assembly LH and RH 
-
Standard distance
Rear
443.8 to 447.8 mm (17.47 to 17.63 in.)

Distance between the centers of the 2 installation bolts of the rear No. 2 suspension arm assembly 
-
Standard distance
Rear
448.9 to 450.9 mm (17.67 to 17.75 in.)