Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER RESISTOR

BLOWER RESISTOR > INSPECTION

for Preparation Click here



1. INSPECT BLOWER RESISTOR


    E032877E12
  1. Disconnect the connector from the blower resistor.
    Text in Illustration 
    *a
    Component without harness connected
    (Blower Resistor)

    HINT:
    There is a fuse between terminals 1 and 3.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 4
    Always
    2.92 Ω
    1 - 3
    Always
    0.44 Ω
    1 - 2
    Always
    1.12 Ω

    If the resistance is not as specified, replace the blower resistor.