STEERING WHEEL > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 4. REMOVE HORN BUTTON ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a screwdriver, push in the 3 torsion springs to disengage the 3 pins.
| *1 | Torsion Spring |
Pull out the horn button assembly from the steering wheel assembly and support the horn button assembly with one hand.
for Dual Airbag System
![]() |
Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Horn Connector |
| *4 | Airbag Connector Lock |
Disconnect the 2 airbag connectors to remove the horn button assembly.
Disconnect the horn connector from the horn button assembly.
for Single Airbag System
![]() |
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Horn Connector |
| *4 | Airbag Connector Lock |
Disconnect the airbag connector to remove the horn button assembly.
Disconnect the horn connector from the horn button assembly.
| 5. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the steering wheel assembly set nut.
| *1 | Matchmark |
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.
![]() |
Using SST, remove the steering wheel assembly.
| *a | Turn |
| *b | Hold |
| 6. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for Automatic Transmission) |
![]() |
Detach the clamp.
![]() |
Remove the 4 screws and remove the shift paddle switch (transmission shift switch assembly).
| 7. REMOVE STEERING SHAKE DAMPER |
![]() |
Remove the 2 screws and steering shake damper from steering wheel assembly.
| 8. REMOVE LOWER STEERING WHEEL BOSS COVER (w/ Cruise Control System) |
![]() |
Remove the 4 screws.
Engage the 2 claws and remove the lower steering wheel cover and cruise control main switch assembly.
Disengage the clamp and disconnect the cruise control main switch wire connector.
| 9. REMOVE LOWER STEERING WHEEL BOSS COVER (w/o Cruise Control System) |
![]() |
Remove the 2 screws.
Disengage the 2 claws and remove the lower steering wheel boss cover.
| 10. REMOVE NO. 1 STEERING WHEEL ORNAMENT |
![]() |
Disengage the 2 claws and guide to remove the No. 1 steering wheel ornament.