VSC OFF SWITCH > INSPECTION |
| 1. INSPECT PATTERN SELECT SWITCH ASSEMBLY |
Make sure that there is no looseness in the locking part and the connecting part of the VSC OFF switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Pattern Select Switch Assembly) |
| Tester Connection | Check Condition | Specified Condition |
| 5 - 8 | Switch not pushed in | 10 kΩ or higher |
| Switch pushed in | Below 1 Ω |
Make sure that there is no looseness in the locking part and the connecting part of the VSC SPORT switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Check Condition | Specified Condition |
| 1 - 8 | Switch not pushed in | 10 kΩ or higher |
| Switch pushed in | Below 1 Ω |
Check the illumination status
Check the illumination when the battery voltage is applied between the connector terminals.
| Check Condition | Specified Condition |
| Battery positive → 2 Battery negative → 3 | The illumination comes on |