Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER COVER
  1. Connect each connector.

  1. Engage the 7 claws to install the front bumper cover.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 4 clips.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the 7 clips.

  1. Install the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



2. INSTALL FRONT BUMPER UPPER RETAINER
  1. Install the front bumper upper retainer with the 5 bolts.

  1. Install the 2 clips.



3. INSTALL FRONT MARKER LIGHT ASSEMBLY LH (w/ Side Marker Light)
  1. Connect the connector.

  1. Engage the claw to install the front marker light assembly.



  1. Check that the side front marker light assembly is installed securely.

    HINT:
    B314973E01
    If the front marker light assembly is not installed securely, widen and adjust the claw.

    Standard:
    Area
    Specified Condition
    a
    3.0 mm (0.118 in.)

    Text in Illustration 
    *1
    Front Marker Light Assembly
    *2
    Claw



4. INSTALL FRONT MARKER LIGHT ASSEMBLY RH (w/ Side Marker Light)

HINT:
Use the same procedure described for the LH side.



5. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH (w/o Side Marker Light)
  1. Connect the connector.

  1. Engage the claw to install the side turn signal light assembly.



  1. Check that the side turn signal light assembly is installed securely.

    HINT:
    B314973E01
    If the side turn signal light assembly is not installed securely, widen and adjust the claw.

    Standard:
    Area
    Specified Condition
    a
    3.0 mm (0.118 in.)

    Text in Illustration 
    *1
    Side Turn Signal Light Assembly
    *2
    Claw



6. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY RH (w/o Side Marker Light)


7. INSTALL HEADLIGHT CLEANER WASHER NOZZLE COVER (w/ Headlight Cleaner System)


    B405804
  1. Engage the claw to install the headlight cleaner washer nozzle cover.